This signal comes from the output of the preamplifier stage on each input channel, prior to the A/D converter and subsequent digital signal processing. Then adjust the TRIM conĭX810 – 11 USING THE DIRECT OUTPUTS The DIRECT OUTPUTS provide an unbalanced line- level signal from each of the 8 Input channels. Slowly increase the TRIM control to the center position (12 o ’ clock), which is unity gain. Start the program source playback for all sources connected to the BUS A or BUS B input. Make sure the power switch is off while setting up and making connections tġ0 – DX810 Bus A and B Input T rim There is no metering after the BUS A and B input TRIM controls. However, this Quick Start section provides a quick overview to get the DX810 set up and working fast.
EAW DX810 DIGITAL SIGNAL PROCESSOR MANUAL
OPERA TION QUICK ST ART Reading the instruction manual is the only way to fully understand the features and functions of the DX810. N/C GROUND SYSTEM OK LOGIC OUT 11 LOGIC OUTĭX810 – 9 – + G G + – MIC LINE 4. In addition, there is an 11th fixed logic output to indicate "System OK." They are all active- low circuits. There are 10 programmable logic inputs and 10 programmable log ic outputs. Note: With screw-down connectors, it ’ s best to use stranded wire thaĨ – DX810 Connecting the LOGIC I/O This is a 25-pin D-Sub connector. The better the shield, the better the audio signal is protected from induced EMI and RFI. INST ALLA TION CONNECTIONS Connecting Balanced Sources Use high-quality three-conductor cable for balanced connections, such as Star Quad by Belden, Canare, or Mogami, etc. These inputs can be used to control a wide variety of DX810 functions via external switching. LOGIC I/O This 25-pin D-Sub connector provides 10 logic control inputs and 10 logic control outputs (open-collector).
![eaw dx810 digital signal processor eaw dx810 digital signal processor](https://img.yumpu.com/11475412/1/190x245/fb1sb-install-instructionspdf-eaw.jpg)
This allows adjustment of levels to both mix outputs from the same set of input controls. A MODE button is used to select between Mix A and B. Levels are set by means of UP/ DOWN pushbuttons dedicated to each input and output. Output meters indicate the actual level at output (post-fader).